View: 236|Reply: 2

Nissan Almera, Tino SE '07. Intermittant Starting Fault.

[Copy link]

11610K

Threads

12810K

Posts

37310K

Credits

Administrators

Rank: 9Rank: 9Rank: 9

Credits
3732793
24-11-2019 22:35:06 Mobile | Show all posts |Read mode
I have an Nissan Almera, 2007. That is unreliable in damp/wet weather as car refuses to start. I think the fault lies with the NATS system, alarm immobizer. Where is it located in engine bay? Help, any ideas?
Reply

Use magic Report

11610K

Threads

12810K

Posts

37310K

Credits

Administrators

Rank: 9Rank: 9Rank: 9

Credits
3732793
24-11-2019 22:35:07 Mobile | Show all posts
From memory, the NATS system is inside the car under the dash somewhere, possibly around the steering column.
Does the engine spin over but not catch or do you just get a click?
Usually if the NATS is playing up you get a key icon lit up on the dash....there is nothing you can do with the NATS, it's a dealer only fix.
If you have a second key see how it goes using that.
I don't remember exactly, but there is a reset you can do by turning the key on and off 5 times or to disconnect the battery for a minimum of 30 minutes then reconnect...if you try this, be sure you have the radio code.
Some Nissans can be reset by using a key that is known to work...turn on the car and crank it over but not start 3 times then allow the car to start on the 4th turn of the key.
It's a long time since I fixed one of these!
Reply Support Not support

Use magic Report

11610K

Threads

12810K

Posts

37310K

Credits

Administrators

Rank: 9Rank: 9Rank: 9

Credits
3732793
 Author| 24-11-2019 22:35:08 Mobile | Show all posts
Thanks, for that. I've since watched 'youtube' & it's been an enormous help. The red key/on car symbol was flashing on the dash, when car wouldn't start. It's the transponder on the ignition-key switch on the steering. I'll take the bottom cowlin off, to expose it, psh-in clip & pull block-connector apart, replace & it resets it, & more than likely the NATS will reset enabling engine to start!!!
So, far the fault hasn't returned. I'm not sure whether it's a damp problem?
Reply Support Not support

Use magic Report

You have to log in before you can reply Login | register

Points Rules

返回顶部